• By Albert Depew

Fire Extinguishers

Press Enter to show all options, press Tab go to next option

Serving with pride, commitment, and compassion

When used properly, a portable fire extinguisher can save lives and property by putting out a small fire or controlling it until the fire department arrives. Portable extinguishers, are not designed to fight large or spreading fires. However, even against small fires, they are useful only under certain conditions:

  • The operator must know how to use the extinguisher. There is no time to read directions during an emergency.
  • The extinguisher must be within easy reach and in working order, fully charged.
  • Some models are unsuitable for use on grease or electrical fires.

Select Your Extinguisher

Choose your extinguisher carefully. A fire extinguisher should bear the seal of an independent testing laboratory. It should also be labeled as to the type of fire it is intended to extinguish.

The extinguisher must be large enough to put out the fire. Most portable extinguishers discharge completely in as few as eight seconds.

Classes of Fires

There are three basic classes of fires. All fire extinguishers are labeled with standard symbols for the classes of fires they can put out. A red slash through any of the symbols tells you the extinguisher cannot be used on that class fire. A missing symbol tells you only that the extinguisher has not been tested for use on a given class of fire.

fire_ext_A.gifClass A Fire Extinguisher: This fire extinguisher is used on common combustibles by soaking and cooling the fibers to prevent re-ignition. It uses either pressurized water, foam or multipurpose (ABC-rated*) dry chemical extinguishers. Carbon Dioxide or normal (BC-rated*) dry chemical extinguishers are not to be used on class A fires.

fire_ext_B.gifClass B fire extinguishers are for flammables.Class B Fire Extinguisher: This fire extinguisher is used on flammable liquids, greases or gases. They work by removing the oxygen and preventing any vapors from reaching a new ignition source or starting the chemical chain reaction. It uses foam, carbon dioxide, normal (BC-rated*) dry chemical, multipurpose (ABC-rated*)dry chemical, and halon mediums.

fire_ext_C.gifClass C fire extinguishers are for electrical equipment.Class C Fire Extinguisher: This fire extinguisher is used to extinguish energized electrical equipment by using an extinguishing medium not capable of conducting electricity. Carbon dioxide, ordinary (BC-rated*) dry chemical, multipurpose (ABC-rated*), and halon** fire extinguishers may be used to fight Class C fires.

Many household fire extinguishers are "multipurpose" A-B-C models, labeled for use on all three classes of fire. If you are ever faced with a Class A fire, and you don't have an extinguisher with an "A" symbol, don't hesitate to use one with the "B:C" symbols.

Warning: It is dangerous to use water or an extinguisher labeled only for Class A fires on a grease or electrical fire.

For electrical equipment (computers, printers, coffee pots, etc.) disconnect the power source then discharge the Class A extinguisher if that is the only type available.

Extinguisher sizes: Portable extinguishers are also rated for the size of fire they can handle. This rating is a number from 1 to 40 for Class A fires and 1 to 640 for Class B fires. The rating will appear on the label. The larger the number, the larger the fire extinguisher can put out. Higher-rated models are often heavier. Make sure you can hold and operate the extinguishers are rated 1A or 2A and/or 5B, 10B, or 20B. The "C" just indicates that you can use it on electrical fires.

Installation and Maintenance

Extinguishers should be installed in plain view above the reach of children near an escape route and away from stoves and heating appliances.

Extinguishers require routine care. Read the operator's manual for you home extinguisher and ask your dealer how it should be inspected and serviced. Rechargeable models must be serviced after every use. Disposable fire extinguishers can be used only once; they must be replaced after one use. Following manufacturer's instructions, check the pressure in your extinguishers once a month. The Carson City Fire Department performs inspection.

Remember The Password

Stand 6 to 8 feet away from the fire and follow the four-step PASS procedure. If the fire does not begin to go out immediately, leave the area at once. Always be sure the fire department inspects the fire site.

PULL the pin out: This unlocks the operating lever and allows you to discharge the extinguisher. Some extinguishers have other devices that prevent inadvertent operation.

AIM low: Point the extinguisher nozzle (or hose) at the base of the fire.

SQUEEZE the lever below the handle: This discharges the extinguishing agent. Releasing the lever will stop the discharge. Some extinguishers have a button that you press.

SWEEP from side to side: Moving carefully toward the fire, keep the extinguisher aimed at the base of the fire and sweep back and forth until the flames appear to be out. Watch the fire area. If the fire re-ignites, repeat the process.
Should You Fight The Fire?

Before you begin to fight a fire:

  • Make sure everyone has left, or is leaving, the building.
  • Make sure the fire department has been notified!
  • Make sure the fire is confined to a small area and that it is not spreading beyond the immediate area.
  • Make sure you have an unobstructed escape route to which the fire will not spread.
  • Make sure that you have read the instructions and that you know how to use the extinguisher.
  • It is dangerous to fight a fire under any other circumstances. We strongly encourage you to leave the area immediately and close off the doors and windows (if possible). Then call 9-1-1.

<Back ^Top